Roll Up Motors and Controls

Roll Up Motors

These durable motors (24 volt, DC) come with built in limit switches and LED operating indicator lights.

torque: 90 Newton meters (Nm) RPM: 2.7 (2.5 under max. load) amps: 4 (5 max. load) max. revolutions : 55	torque: 120 Nm RPM: 1.5 (1.4 max. load) amps: 3.7 (4.9 max. load) max. revolutions : 33
90 Nm roll up motor with telescopic tube assembly to mount to an endwall, $275.00 90 Nm roll up motor with 12 wheel trolly and 2 metre guide tube, $335.00	120 Nm roll up motor with telescopic tube assembly to mount to an endwall, $350.00 120 Nm roll up motor with 12 wheel trolley and 2 metre guide tube, $410.00
One revolution equals approximately 6” of vertical wall travel.

trolley assembly	telescopic tube assembly

Roll Up Motor Controls

Incremental controller for thermostat input -
comes with a manual override

Thermostat - Nema 4 enclosure
for greenhouse conditions

Automate your roll up walls for a more consistent environment and crop.

Our controllers will operate 2 roll up motors - they plug into any standard 110v. outlet. The motors are individually fused.

The incremental controllers energize every 10 minutes (adjustable), if the temperature is above the thermostat set point, the wall rises 6" (adjustable).
If the temperature is below the set point, the wall drops 6".
Limit switches on the motors determine the lower and upper travel of the motors.

There is a computer input model (compatible with Argus, Priva, etc) and a thermostat input model.

incremental controller, computer: $890
incremental controller, thermostat: $890
basic open/close controller, manual input: $325
thermostat for the roll up motor (40 to 110 degrees F) $75

Thermostats or computers not included in the controller prices.